Pco C++ Tango device

This is the reference documentation of the Pco Tango C++ device.

You can also find some useful information about the camera models/prerequisite/installation/configuration/compilation in the Pco camera plugin section.

Properties

Property name	Default value	Type	Description
SerialNumber	0	String	Serial Number of the camera: used to select camera if several connected to the same host; default : 0 (ie select the 1st camera found)

Attributes

Attribute name	Read/Write	Type	Description
pixelRate	R/W	String	Get / Set the Pixel Rate in Hz
doubleImage	R/W	Boolean	Get / Set the double image mode
currentRecordedFrame	R	Ulong	Current recorded frame : frames recorded in the Camera RAM
cameraModel	R	String	Model of the camera
sensorTemperature	R	Float	Image sensor temperature in degree celcius
forcedFIFOMode	R/W	Boolean	Get / Set the forced FIFO mode
dllVersion	R	String	Version of the SC2_cam.dll

Optionnal attributes (depend on camera model)

Attribute name	Read/Write	Type	Description
maxNbImage	R	Ulong	Get the max number of images available in the Camera RAM: depending on the Roi (Dimax, 4000, 2000, 1600)
cdiMode	R/W	Boolean	Get / Set the cdi mode (Dimax)
frameRate	R	Double	Get the current frame rate (Dimax, Edge)
coolingSetPoint	R/W	Short	Get / Set the cooling set point in degree celcius (4000, 2000, 1600, Edge)
adcOperation	R/W	String	Get / Set the adc operation: (4000, 2000, 1600) SINGLE DUAL
shutterMode	R/W	String	Get / Set the shutterMode operation: (Edge) ROLLING_SHUTTER GLOBAL_SHUTTER GLOBAL_RESET

Commands

Command name	Arg. in	Arg. out	Description
Init	Void	Void	Do not use
State	Void	Long	Return the device state
Status	Void	String	Return the device state as a string
GetCamInfo	Void	String	Get Camera Infos
Talk	String	String	Availables values are: ? (get all available parameters) lasterror camInfo camType clTransferParam cocRunTime frameRate maxNbImages timestamp